chinese style chest of drawers – Wooden drawers, over time may create niggling little defects that we always put up with, inconvenient and bothersome as they may be when really – the vast majority of these problems are relatively easy to fix. Drawers at which the base has broken and sticking drawers are probably the most common issues experienced. With just a little knowledge these may be rectified without needing to begin calling around for a joiner since the initial or our only option.
Overloading drawers may often be the main reason for sticking drawers. The very first step would be to fully empty the drawer and remove for inspection. Check for protruding or loose nails or pins either on the jar or at and about the drawer frame. It could be that straightforward.
Tip. This may just do the task with no additional work.
Drawer runners could also be the culprit. Check how smoothly the lure slides across the wooden runners. Should they’ve worked loose it may be the reason behind sticking; again, usually because of overloading. In that case, then simply apply new adhesive to the runner and then pin back into position.
Worn runners are another common reason for drawer issues. The uppermost sides can get worn with use and time. Check that the underside of the runner remains great – it may be possible to simply remove the runner and turn it over. In that case, then cautiously prise it off with a wood chisel- apply adhesive- and re-pin into place.
New runners could be demanded if turning the old runners around doesn’t solve the issue of sticking. Where this is the case cut a few bits of wood to the same dimensions as the first runners, smooth with a moderate abrasive paper and drill together with the smallest wood drill bit on your arsenal to take the small diameter of the fixing panel nails or pins. Apply a thin coating of wood adhesive to the rear of the runner- press place- and affix with pins.
Drawer bases may also suffer the negative effects of overloading. In time they will begin to sag, and eventually they can split completely, requiring replacement. In this case, cut on a fresh base bit from plywood or by a hardwood of selection. Next, remove the nails or pins securing the damaged base to the body of this drawer utilizing pincers and remove any glue blocks that may be attached with a mallet and wood chisel. Replace with fresh base by gluing and utilizing pins.
Drawer bases that are broken may be occasionally mended, that is to say; just remove both halves in the drawer body and then paste them back together. From a strength perspective, depending on utilization, this may not be the best option.