concealed drawer lock


concealed-drawer-lock concealed drawer lock

concealed drawer lock – Wooden drawers, over time may develop niggling little faults which we always put up with, awkward and annoying as they may be when actually – the vast majority of those problems are relatively easy to repair. Drawers where the base has split and sticking drawers are possibly the most frequent issues experienced. With only a little knowledge these may be rectified without needing to begin phoning around for a joiner since the first or our only option.

Overloading drawers may often be the main cause of sticking drawers. The first step would be to completely empty the drawer and remove for review. Check for loose or protruding nails or pins either on the drawer or at and around the drawer frame. Where obvious; hammer flush and refit drawer. It might be that simple.

Tip. This may just do the task without any further work.

Drawer runners could also be the culprit. Assess how easily the draw slides across the wooden runners. If they’ve worked loose it may be the cause of sticking; again, usually because of overloading. In that case, then just apply new adhesive to the runner and then pin into place.

Worn runners are another frequent cause of drawer issues. The uppermost sides can become worn with use and time. Check that the underside of the runner is still great – it may be possible to just remove the runner and turn it over. In that case, then cautiously prise it off using a wood chisel- apply adhesive- and re-pin right into position.

New runners could be required if turning the old runners around does not fix the issue of sticking. Apply a thin coat of wood adhesive to the back of the new runner- press into position- and affix with pins.

Drawer bases may also suffer the negative effects of overloading. In time they’ll begin to sag, and eventually they can split entirely, requiring replacement. In cases like this, cut a new base piece from either plywood or by a hardwood of choice. Next, remove the pins or nails securing the damaged base to the entire body of the drawer utilizing pincers, and remove any glue blocks which might be attached using a mallet and wood chisel. Replace with new base by gluing and utilizing pins.

From a strength point of view, based on utilization, this might not be the best option.

Originally posted 2016-12-10 21:21:33.

Leave a reply "concealed drawer lock"