locking mechanisms for hidden drawers – Wooden drawers, over time may develop niggling little faults which we invariably put up with, inconvenient and bothersome as they may be – when actually – the vast majority of those problems are relatively easy to fix. Drawers at which the base has split and sticking drawers are possibly the most frequent problems experienced. With just a little understanding these may be rectified without having to start phoning around for a joiner as the initial or our sole alternative.
Overloading drawers may often be the root cause of sticking drawers. The first step is to fully empty the drawer and eliminate inspection. Check for protruding or loose pins or nails either on the drawer or at and about the drawer framework. It could be that simple.
Tip. Before getting the toolkit out for sticking drawers; initial attempt rubbing the runners and drawer grooves with candle wax. This might just do the task with no additional work.
Drawer runners are also the culprit. Assess how easily the lure slides across the wooden runners. Should they have worked loose it may be the cause of sticking; again, usually due to overloading. If so, then simply apply fresh adhesive to the runner and then pin back into position.
The uppermost sides can get worn with time and use. Check the bottom of the runner remains great – it might be possible to simply eliminate the runner and turn it over. If so, then carefully prise off it using a wood chisel- apply adhesive- and re-pin right into place.
New runners may be demanded if turning the old runners around doesn’t fix the issue of sticking. Apply a thin coat of wood adhesive to the back of the new runner- press into place- and combine with pins.
Drawer bases may also suffer the negative effects of overloading. In time they’ll begin to sag and eventually they can split completely, requiring replacement. In this case, cut a new base bit from either plywood or from a hardwood of selection. Then remove the pins or nails securing the damaged base to the body of the drawer utilizing pincers, and eliminate any glue blocks which might be attached using a mallet and wood chisel. Replace with new base by gluing and utilizing pins.
From a strength perspective, based on usage, this might not be the best option.