narrow nightstands with drawers – Wooden drawers, over time can develop niggling little faults which we invariably put up with, inconvenient and bothersome as they can be – when actually – the vast majority of those problems are rather easy to fix. Drawers at which the foundation has split and sticking drawers are probably the most common problems experienced. With only a little understanding these can be rectified without having to start phoning around for a joiner as the initial or our only option.
Overloading drawers can often be the main reason for sticking drawers. The very first step is to fully empty the drawer and remove for review. Check for protruding or loose nails or pins either on the drawer or in and about the drawer framework. It might be that simple.
Tip. Before getting the toolkit out for sticking drawers; initial try rubbing the runners and drawer grooves with candle wax. This might just do the task without any additional work.
Drawer runners could also be the culprit. Assess how easily the lure slides across the wooden runners. Should they have worked loose it can be the cause of sticking; again, usually because of overloading. If so, then just apply fresh adhesive to the runner and then pin into position.
Worn runners are another common reason for drawer problems. The uppermost sides can become worn with time and use. Check the underside of the runner remains great – it might be possible to just eliminate the runner and turn it over. If so, then cautiously prise off it using a wood chisel- apply adhesive- and re-pin right into place.
New runners could be required if turning the previous runners around doesn’t solve the problem of sticking. Where this is the case cut a couple of bits of wood to the exact dimensions as the first runners, smooth with a medium abrasive paper and drill together with the smallest wood drill bit in your toolbox to take the small diameter of the fixing panel nails or pins. Apply a thin coating of wood adhesive to the back of the runner- press place- and combine with pins.
Drawer bases can also suffer the negative effects of overloading. In time they’ll begin to sag, and eventually they can split entirely, requiring replacement. In cases like this, cut on a new foundation bit from either plywood or by a hardwood of selection. Next, remove the nails or pins securing the damaged foundation to the entire body of this drawer utilizing pincers and eliminate any glue blocks which might be attached using a mallet and wood chisel. Replace with new foundation by gluing and utilizing pins.
Drawer bases which are split may be occasionally mended, that is to say; simply get rid of both halves from the drawer body and then glue them back together. From a strength point of view, depending on utilization, this might not be the most suitable choice.
Originally posted 2017-06-07 10:18:33.