plastic storage carts with drawers – Wooden drawers, over time can create niggling little faults which we always put up with, awkward and annoying as they can be – when really – the vast majority of these problems are rather simple to repair. Drawers at which the base has broken and sticking drawers are possibly the most common problems experienced. With only a little knowledge these can be rectified without needing to start calling around for a joiner as the initial or our only alternative.
Overloading drawers can often be the root reason for sticking drawers. The very first step would be to completely empty the drawer and eliminate inspection. Check for loose or protruding pins or nails either on the jar or in and around the drawer framework. Where obvious; hammer back flush and refit drawer. It might be that simple.
Tip. Before getting the toolkit out for sticking drawers; initial try rubbing the runners and drawer grooves with candle wax. This may just do the job without any additional effort.
Drawer runners are also the culprit. Check how smoothly the draw slides across the wooden runners. If they have worked loose it can be the cause of sticking; again, generally because of overloading. If so, then just apply fresh adhesive to the runner and pin back into place.
Worn runners are another common reason for drawer problems. The uppermost sides can become worn with time and use. Check the bottom of the runner remains good – it may be possible to just remove the runner and turn it over. If so, then carefully prise it off with a wood chisel- apply adhesive- and re-pin into position.
New runners could be required if turning the old runners round does not solve the problem of sticking. Apply a thin coat of wood adhesive to the back of the runner- press position- and combine with hooks.
Drawer bases can also suffer the negative effects of overloading. In time they’ll begin to sag and they can split completely, requiring replacement. In cases like this, cut a new base piece from either plywood or by a hardwood of selection. Then remove the nails or pins securing the damaged base to the entire body of the drawer utilizing pincers and remove any glue blocks which might be attached using a mallet and wood chisel. Replace with new base by gluing and utilizing hooks.
Drawer bases which are broken may be sometimes repaired, that is to say; simply get rid of both halves in the drawer body and paste them back together. From a strength point of view, depending on usage, this might not be the best option.