sauder shoal creek 4 drawer chest soft white – Wooden drawers, over time can create niggling little defects that we invariably put up with, inconvenient and annoying as they can be – when really – the majority of those problems are rather simple to fix. Drawers at which the foundation has broken and sticking drawers are probably the most common problems experienced. With just a little understanding these can be rectified without having to begin calling around for a joiner as the initial or our only option.
Overloading drawers can often be the root cause of sticking drawers. The first step would be to fully empty the drawer and remove for review. Check for loose or protruding pins or nails either on the jar or in and around the drawer frame. It might be that straightforward.
Tip. Before obtaining the toolkit out for sticking drawers; initial attempt rubbing on the runners and drawer grooves with candle wax. This may just do the job with no further work.
Drawer runners are also the culprit. Assess how easily the lure slides along the wooden runners. If they’ve worked loose it can be the cause of sticking; again, usually due to overloading. If so, then just apply new glue to the runner and pin into place.
The uppermost sides can become worn with time and use. Check that the bottom of the runner remains great – it may be possible to just eliminate the runner and turn it over. If so, then cautiously prise it off using a wood chisel- apply glue- and re-pin right into place.
New runners may be required if turning the previous runners round does not fix the problem of sticking. Where this is the case cut a few pieces of wood to the same dimensions as the original runners, smooth with a medium abrasive paper and drill together with the tiniest wood drill bit in your arsenal to take the small diameter of the fixing panel pins or nails. Apply a thin coat of wood glue to the back of the runner- press place- and affix with pins.
Drawer bases can also suffer the adverse effects of overloading. In time they will start to sag and eventually they can split completely, requiring replacement. In this case, cut on a new foundation bit from plywood or from a hardwood of selection. Next, remove the pins or nails securing the damaged foundation to the body of this drawer using pincers, and eliminate any glue blocks which might be attached with a mallet and wood chisel. Replace with new foundation by gluing and using pins.
From a strength perspective, depending on usage, this might not be the best option.