self adhesive felt drawer liner – Wooden drawers, over time can create niggling little faults which we invariably put up with, awkward and annoying as they can be – when really – the vast majority of these problems are relatively easy to fix. Drawers where the base has split and sticking drawers are probably the most frequent issues experienced. With just a little knowledge these can be rectified without having to begin calling around for a joiner as the first or our sole alternative.
Overloading drawers can often be the root reason for sticking drawers. The very first step would be to completely empty the drawer and eliminate review. Check for protruding or loose pins or nails either on the drawer or in and around the drawer frame. It might be that straightforward.
Tip. Before obtaining the toolkit out for sticking drawers; first attempt rubbing the runners and drawer grooves with candle wax. This might just do the task with no additional effort.
Drawer runners are also the culprit. Assess how smoothly the draw slides along the wooden runners. Should they’ve worked loose it can be the cause of sticking; again, generally due to overloading. If so, then just apply new glue to the runner and then pin into position.
Worn runners are another frequent reason for drawer issues. The uppermost sides can become worn with use and time. Check the underside of the runner is still great – it might be possible to just remove the runner and flip it over. If so, then carefully prise off it with a wood chisel- apply glue- and re-pin right into place.
New runners could be demanded if turning the old runners around doesn’t fix the problem of sticking. Where this is the case cut a few bits of timber to the exact dimensions as the first runners, smooth with a medium abrasive paper and drill with the smallest wood drill bit in your toolbox to choose the small diameter of the fixing panel pins or nails. Apply a thin coat of wood glue to the rear of the runner- press into place- and combine with pins.
Drawer bases can also suffer the negative effects of overloading. In time they will start to sag and they can split completely, requiring replacement. In this case, cut a fresh base bit from plywood or from a hardwood of choice. Next, remove the pins or nails securing the damaged base to the body of the drawer utilizing pincers and remove any glue blocks which may be attached with a mallet and wood chisel. Replace with fresh base by gluing and utilizing pins.
Drawer bases which are split may be sometimes mended, that is to say; simply get rid of both halves in the drawer body and then paste them back together. From a strength perspective, depending on utilization, this may not be the best option.