small chest of drawers for closet – Wooden drawers, over time may develop niggling little faults which we invariably put up with, awkward and annoying as they may be when actually – the majority of these problems are relatively easy to repair. Drawers at which the foundation has broken and sticking drawers are probably the most common issues experienced. With only a little understanding these may be rectified without needing to start calling around for a joiner as the first or our only option.
Overloading drawers may often be the root cause of sticking drawers. The first step would be to fully empty the drawer and remove for review. Check for protruding or loose nails or pins either on the jar or in and about the drawer framework. It could be that straightforward.
Tip. This may just do the job with no additional effort.
Drawer runners could also be the culprit. Assess how smoothly the lure slides along the wooden runners. Should they have worked loose it may be the reason behind sticking; again, generally due to overloading. In that case, then simply apply new glue to the runner and pin back into position.
Worn runners are another common cause of drawer issues. The uppermost sides can get worn with time and use. Check that the bottom of the runner is still good – it may be possible to simply eliminate the runner and turn it over. In that case, then carefully prise off it with a wood chisel- apply glue- and re-pin into position.
New runners could be demanded if turning the old runners round does not solve the issue of sticking. This is the case cut a couple of pieces of wood to the exact dimensions as the first runners, smooth with a moderate abrasive paper and drill with the smallest wood drill bit on your arsenal to take the small diameter of the fixing panel nails or pins. Apply a thin coating of wood glue to the rear of the new runner- press into position- and combine with hooks.
Drawer bases may also suffer the negative effects of overloading. In time they will start to sag, and they can split completely, requiring replacement. In this case, cut on a new foundation bit from either plywood or by a hardwood of choice. Next, remove the nails or pins securing the damaged foundation to the body of this drawer using pincers, and eliminate any glue blocks that might be attached with a mallet and wood chisel. Replace with new foundation by gluing and using hooks.
From a strength perspective, depending on utilization, this might not be the most suitable choice.
Originally posted 2017-12-08 19:21:22.