tall wood storage cabinets with drawers – Wooden drawers, over time may create niggling little faults which we always put up with, awkward and bothersome as they may be – when really – the majority of those problems are relatively simple to fix. Drawers at which the base has broken and sticking drawers are probably the most common problems experienced. With just a little knowledge these may be rectified without having to start phoning around for a joiner since the initial or our only option.
Overloading drawers may often be the root reason for sticking drawers. The very first step is to completely empty the drawer and eliminate review. Check for loose or protruding nails or pins either on the drawer or at and about the drawer framework. It might be that straightforward.
Tip. This might just do the job with no further effort.
Drawer runners are also the culprit. Assess how smoothly the lure slides across the wooden runners. Should they’ve worked loose it may be the cause of sticking; again, generally because of overloading. If so, then just apply new adhesive to the runner and pin into place.
Worn runners are another common reason for drawer problems. The uppermost sides can get worn with time and use. Check that the bottom of the runner remains good – it might be possible to just remove the runner and flip it over. If so, then carefully prise off it using a wood chisel- apply adhesive- and re-pin right into position.
New runners may be required if turning the previous runners round doesn’t fix the issue of sticking. This is the case cut a few pieces of wood to the exact dimensions as the first runners, smooth with a moderate abrasive paper and drill with the tiniest wood drill bit in your arsenal to choose the small diameter of the fixing panel nails or pins. Apply a thin coating of wood adhesive to the rear of the runner- press into position- and affix with pins.
Drawer bases may also suffer the adverse effects of overloading. In time they’ll begin to sag and they can split completely, requiring replacement. In cases like this, cut on a fresh base piece from either plywood or from a hardwood of choice. Next, remove the pins or nails securing the damaged base to the body of the drawer utilizing pincers, and remove any glue blocks that might be attached with a mallet and wood chisel. Replace with fresh base by gluing and utilizing pins.
Drawer bases that are broken may be occasionally mended, that is to say; just get rid of both halves from the drawer body and glue them back together. From a strength point of view, based on usage, this might not be the best option.