western style drawer pulls

42 views

western-style-drawer-pulls western style drawer pulls

western style drawer pulls – Wooden drawers, over time may develop niggling little defects that we invariably put up with, awkward and bothersome as they may be – when actually – the majority of those problems are relatively simple to repair. Drawers where the foundation has split and sticking drawers are possibly the most frequent problems experienced. With just a little understanding these may be rectified without needing to start phoning around for a joiner since the first or our sole option.

Overloading drawers may often be the main reason for sticking drawers. The very first step is to completely empty the drawer and remove for review. Check for protruding or loose pins or nails either on the drawer or at and around the drawer frame. It might be that straightforward.

Tip. This may just do the job without any additional effort.

Drawer runners are also the culprit. Check how easily the draw slides along the wooden runners. If they’ve worked loose it may be the cause of sticking; again, generally due to overloading. In that case, then simply apply new glue to the runner and pin back into position.

The uppermost sides can become worn with time and use. Check the underside of the runner remains good – it may be possible to simply eliminate the runner and turn it over. In that case, then cautiously prise it off using a wood chisel- apply glue- and re-pin into position.

New runners could be demanded if turning the old runners round does not fix the issue of sticking. Apply a thin coating of wood glue to the rear of the new runner- press into position- and affix with hooks.

Drawer bases may also suffer the negative effects of overloading. In time they’ll begin to sag and they can split completely, requiring replacement. In this case, cut a fresh foundation piece from plywood or from a hardwood of choice. Then remove the pins or nails securing the damaged foundation to the entire body of the drawer utilizing pincers and eliminate any glue blocks that might be attached using a mallet and wood chisel. Replace with fresh foundation by gluing and utilizing hooks.

Drawer bases that are split may be occasionally repaired, that is to say; simply remove both halves in the drawer body and glue them back together. From a strength point of view, depending on usage, this might not be the most suitable choice.