wooden desk drawer locks

68 views

wooden-desk-drawer-locks wooden desk drawer locks

wooden desk drawer locks – Wooden drawers, over time can develop niggling little defects that we invariably put up with, awkward and bothersome as they can be – when actually – the vast majority of these problems are relatively easy to repair. Drawers at which the base has broken and sticking drawers are probably the most common problems experienced. With only a little understanding these can be rectified without having to begin phoning around for a joiner as the initial or our only alternative.

Overloading drawers can often be the main reason for sticking drawers. The very first step would be to fully empty the drawer and remove for review. Check for loose or protruding nails or pins either on the drawer or at and about the drawer frame. Where evident; hammer back flush and refit drawer. It might be that simple.

Tip. This may just do the job with no further work.

Drawer runners could also be the culprit. Assess how smoothly the draw slides along the wooden runners. Should they’ve worked loose it can be the reason behind sticking; again, usually because of overloading. If so, then just apply new adhesive to the runner and then pin back into position.

Worn runners are another common reason for drawer problems. The uppermost sides can become worn with time and use. Check that the underside of the runner remains good – it may be possible to just remove the runner and flip it over. If so, then cautiously prise it off using a wood chisel- apply adhesive- and re-pin right into place.

New runners may be required if turning the old runners around does not solve the problem of sticking. Apply a thin coating of wood adhesive to the back of the runner- press place- and combine with pins.

Drawer bases can also suffer the adverse effects of overloading. In time they will start to sag, and they can split completely, requiring replacement. In cases like this, cut on a fresh base piece from either plywood or from a hardwood of selection. Next, remove the pins or nails securing the damaged base to the body of the drawer utilizing pincers and remove any glue blocks which might be attached with a mallet and wood chisel. Replace with fresh base by gluing and utilizing pins.

Drawer bases which are broken may be sometimes mended, that is to say; just get rid of both halves in the drawer body and then glue them back together. From a strength perspective, depending on utilization, this might not be the most suitable choice.

Originally posted 2016-12-21 07:23:06.